![]() ![]() The wiring diagram that came with the heater shows this pin going to a switch of some sort. I am very tempted to stick a paper clip/pin through the harness so that it makes contact with the board at the heater and ground it. ![]() So how would Webasto adjust the Co2 settings with this pin missing? What am I missing? Do they have a special harness they plug into the control board that makes contact lower? (They also said if I had the RV version and a Multicontrol I could set it to an altitude correction mode from the controller, but I don't have that altitude option on my Multicontrol so I don't think I got the RV model). I contacted Webasto's technical support and they said I would need to take it to a dealer and have it calibrated with their magical expensive machines. After a few failed attempts, I pulled out the wiring harness at the heater and have discovered what looks like the pin is missing from the #7 male connector on the control board at the heater. I just installed my Webasto 2000 STC, and I am striking out on the altitude adjustment where I am to ground the brown wire coming from the #7 pin, set the rheostat to 12:00, etc.
0 Comments
Leave a Reply. |